VCT Vision ELITE Series Guia do Utilizador descarregar pdf (Página 10)

suitable.

Click the box on the left to enable the night motion option. In the “From” pull-down bar, select a start time, and select an end

time in the “Till” box. Last, select a sensitivity level from the “Sensitivity” pull-down bar. Now, that sensitivity setting will be active

during the night time hours set by you.

Inserting MD (Motion Detection) Zones

The box below allows you to select each camera individually and insert motion detection zones (specic areas within the video

image to be triggered by motion). You can have up to 16 zones.

To do this, click on the “Insert Zone” box. An image of the area being recorded by the camera number you selected in “Select

Camera Number Mode” will show in the box that is the shaded area above. From there, draw boxed zones into the image

surrounding the area under surveillance you choose to be motion sensitive.

Insert Entire Zone: Selecting this option sets the entire area as an MD Zone.

Clear Zone: This will remove the last motion detection zone you created.

Clear Entire Zone: This will clear the entire zone of motion detection.

NOTIFICATION SETUP

ese settings will program the system to notify you via e-mail when certain events take place within the system.



EmailNotication

To enable the function, click the “Enable Email Notication” box. Next, ll in the necessary elds including email addresses,

SMTP, User ID, and Password.

Notication

Here you can make choices as to when the system sends you an e-mail notication. The system can send a notication e-mail

when it looses a camera signal, detects motion, or both. Select either or both boxes per your preference. Next, the “Inactivity

Timeout” pull-down menu controls the amount of time (in minutes) the system will wait before sending the notication. For

example, if it is set for 10 minutes, when the system looses a signal or detects motion and it continues for 10 minutes, the

system will then send a notication and will continue sending a notication every 10 minutes until the motion stops or the signal

is xed. The “Start Time” and “End Time” options allow you to program specic spans of time (anywhere from 24 hours straight

to a few hours at a time) by entering a “Start Time” for the notication function to activate, and an “End Time” for the notication

function to discontinue.

POS SETUP (NOT AVAILABLE IN LITE VERSION)

If you have chosen a system that includes POS options, the drop down menu to the left will include a “POS Setup”

option and will bring up the screen below.



Select Camera (Camera Number & Terminal Number)

Slide the cursors to the right to select the desired camera and terminal numbers for programming.

POS Text Color

Here you program your POS settings. To enable POS, check the “Enable POS” box. Once checked, select from the “Text

overlay” option, text color, font size, number of text lines you wish to include, and the “Text Alignment”, or where you want the

text to be displayed, and port. Again, the POS Setup box will only be included if your system is one with POS options.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sem comentários

VCT Vision ELITE Series Guia do Utilizador Página 10